Crafco is the world's leading manufacturer of pavement preservation products and equipment.

What equipment does Crafco manufacture?

Crafco manufactures Super Shot melter applicators, pavement routers, sealcoating equipment, heat lances, crack vac systems and more.

Where is Crafco located?

Crafco is headquartered in Chandler Arizona with facilities across the United States.

How do I choose the right crack sealant?

The correct sealant depends on climate zone crack width traffic level and surface type. Crafco technical support can help select the right product.

matrix calculator - Crafco Pavement Preservation

Matrix 501/502 Calculator

This field is for validation purposes and should be left unchanged.

Select a measurement system(Required)

Select Matrix type(Required)

Matrix 501 is typically sold in the United States. Matrix 502 is typically sold outside the United States.

Maximum joint depth in inches

Maximum joint depth in millimeters

Joint width in inches

Joint width in millimeters

Joint length in feet

Joint length in meters

Percent waste to plan for

10 = 10%, the recommended figure.

Results

Adhesive Material needed (Part #33346)

Pounds

Backer Rod Needed (feet)

Part #34609 - Total feet needed, supplied in 6ft sections.

Surfacing Aggregate Needed (lbs)

Part #33375SA

Matrix 501 material needed (Part #33345)

Pounds

Matrix 502 binder needed (Part #34528 or 34529)

Pounds

Part #34528 is the standard grade used in cool to moderate climates, that meets the polymer modified asphalt requirements of ASTM D6297. Part No. 34529 is a stiffer formulation for hotter climates and high traffic areas. Your Crafco representative can help you decide which best meets your use case.

Structural aggregate needed (Part #33033)

Pounds

Bridging Plate Material Needed (feet)

No overage applied. To be sourced locally.

Locating Pins Needed

1 per foot of length. To be sourced locally. We advise using 16d nails.

Results

Provided in Metric units for convenience. If you submit your calculations for a quote, the estimates will be converted to US Imperial units.

Metric

Imperial Conversion

Adhesive material needed (Part #33346)

Kilograms

Adhesive material needed (Part #33346)

Pounds

Backer Rod Needed (Part #34609)

Total meters needed. Supplied in 1.83m/6ft sections.

Backer Rod Needed (Part #34609)

Total feet needed. Supplied in 1.83m/6ft sections.

Surfacing Aggregate Needed (Part #33375SA)

Kilograms

Surfacing Aggregate Needed (Part #33375SA)

Pounds

Matrix 501 material needed (Part #33345)

Kilograms

Matrix 501 material needed (Part #33345)

Pounds

Matrix 502 binder needed (Part #34528 or #34529)

Kilograms

Matrix 502 binder needed (Part #34528 or #34529)

Pounds

Structural aggregate needed (Part #33033

Kilograms

Structural aggregate needed (Part #33033)

Pounds

Bridging plate material needed

Meters. No overage applied. To be sourced locally.

Locating Pins Needed

1 per US foot of length. To be sourced locally. We advise using 16d nails.

Matrix 501/502 Calculator

Results

Results

Metric

Imperial Conversion

Solution Wizard

Request a Quote

About Crafco

Crafco Headquarters

Solutions

Materials

Equipment

Resources

About

Contact