Texas DOT saved $3.2M by using Crafco solutions across 72 lane miles, extending pavement life by 7+ years.
Even the strongest materials need help sometimes. Crafco concrete solutions protect your vital infrastructure from start to finish.
Concrete is exceptionally strong and durable, but it is still vulnerable to chemical and physical degradation. Crafco offers solutions to give your concrete project a good start and quickly handle distresses as they arise.
Crafco Concrete Cures are available in a variety of formulations to match your specific needs, helping concrete reach its maximum strength by minimizing moisture loss and controlling heat during the curing period.
PoreShield is a revolutionary bio-based concrete protectant that blocks deterioration from inside the pore system for 10+ years. PoreShield is safe to spray over water and requires no PPE, special equipment or special training.
Seal sawcut concrete joints with Crafco Roadsaver Silicone to block moisture and incompressible debris without compromising the joint’s ability to move. Roadsaver Silicone is jet-fuel resistant and has a demonstrated service life of 20+ years.
When cracks appear in concrete pavement, Crafco Roadsaver Gray hot-applied sealant provides a durable seal without calling attention to itself.
TechCrete offers a fast, durable repair for a wide range of concrete pavement distresses. This hot-applied mastic material is load-bearing but remains flexible to absorb thermal movement of the surrounding pavement. Best of all, TechCrete is simple to install and ready for traffic as soon as it cools.
For extremely fast concrete repairs that last all season, choose HP Concrete Cold Patch. It stays pliable in storage, requires no mixing or heating, and can be installed even when the pavement is wet.
Texas DOT saved $3.2M by using Crafco solutions across 72 lane miles, extending pavement life by 7+ years.
City of Chicago reduced complaint calls by 82% after implementing a targeted preventive maintenance program.
Concrete must cure slowly to attain full strength. Apply Crafco Concrete Cures to highways, streets, parking garages and other structures to slow moisture loss and reduce heat — factors which speed up curing and compromise strength.
Salt is extremely destructive to concrete. Use PoreShield concrete protectant to block absorption of salt into the concrete pore system, which helps prevent scaling and other types of damage due to salt infiltration.
Concrete joints begin to spall when harmful chemicals and incompressible debris enter the joint. Sealing joints with highly-elastic Crafco Roadsaver Silicone blocks infiltration into this void while still allowing the joint to expand and contract with the seasons.
Some cracking in concrete is inevitable, but leaving cracks unsealed may allow salt and incompressible debris to work its way below the surface or even put the subbase at risk of erosion. Use Crafco Roadsaver Gray hot-applied sealant to quickly and discreetly seal concrete cracks.
Compromised concrete can break in a variety of ways, and pouring new concrete often means major traffic disruptions. Use TechCrete gray hot-applied mastic to permanently repair a wide range of distresses in concrete and re-open to traffic quickly. HP Concrete Cold Patch offers an even faster repair that will last all season and beyond.
These complementary products work together for optimal concrete repair, preservation and protection.
Typically, our bridge deck membranes are ready for traffic within 24 hours of application, depending on temperature and humidity conditions. Please consult the product data sheet for specific cure times.
Typically, our bridge deck membranes are ready for traffic within 24 hours of application, depending on temperature and humidity conditions. Please consult the product data sheet for specific cure times.
Typically, our bridge deck membranes are ready for traffic within 24 hours of application, depending on temperature and humidity conditions. Please consult the product data sheet for specific cure times.
